Setup did not find any hard disk drives installed in your computer.

Make sure any hard disk drives are powerd on and properly connected....

Setup cannot continue. To quite Setup, press F3

The parameter is not valid. Try /? for help.

ducha: 
I kad otkucam chkdsk /? izlista mi samo /P i /R sviceve.

CHKDSK [volume[[path]filename]]] [/F] [/V] [/R] [/X] [/I] [/C] [/L[:size]]


volume Specifies the drive letter (followed by a colon),
mount point, or volume name.
filename FAT/FAT32 only: Specifies the files to check for fragmentation
.
/F Fixes errors on the disk.
/V On FAT/FAT32: Displays the full path and name of every file
on the disk.
On NTFS: Displays cleanup messages if any.
/R Locates bad sectors and recovers readable information
(implies /F).
/L:size NTFS only: Changes the log file size to the specified number
of kilobytes. If size is not specified, displays current
size.
/X Forces the volume to dismount first if necessary.
All opened handles to the volume would then be invalid
(implies /F).
/I NTFS only: Performs a less vigorous check of index entries.
/C NTFS only: Skips checking of cycles within the folder
structure.

The /I or /C switch reduces the amount of time required to run Chkdsk by
skipping certain checks of the volume.

/P Check even if the drive is not flagged dirty

The chkdsk command with the parameters listed below is only available when you are using the Recovery Console The chkdsk command with different parameters is available from the command prompt.