[ AlekreSd @ 28.03.2014. 21:07 ] @
| Vi ste mi jedina preostala nada oko popravke Whirlpool ves masine: Konkretno sta se desava:   Po njima, kod F24 Water overflow detected As with many washing machines the Whirlpool washers using this software have an overflow sensor built into the level switch or sensor, sometimes called a pressure switch. This is a safety measure to prevent flooding but it can be activated for a number of other reasons and, most commonly, by user error. When activated the machine will close the water inlet valves if they are open and switch the drain pump on. The overflow level must have been reached for more than five seconds for these events to happen. Once again, overdosing of detergents or conditioner can cause this error to manifest as excess lather or foam can travel up into the pressure sensor causing the level to be falsely reported to the electronics. Poor quality detergents also tend to foam more than leading brands. Check detergent quality and dose Check water outlet or drain hose for kinks or any blockage Check drain pump filter for foreign objects and/or blockages Check drain pump Check that the water inlet valve is closing correctly Check pressure switch for operation Check pressure switch wiring and connectors Check harness and connectors from the pressure switch to the main controller Problem je u tome sto sam sve to proverio: Ispustno crevo, okej Pumpu sam zamenio, filter cist Presostat, cakne jednom, cakne i drugi put kada ispustam pritisak Zice, kontakti, sve to deluje kako treba. Jedino ne znam za taj ventil, masina radi normalno dok ne dodje do toga da treba vrucu vodu da ispusti, tad blokira. Ako imate neki savet, sta kako, postao sam beznadezan. |